8. Multi-product and multi-site EPDs
How to make one EPD for several products or for a product made at several production sites in the EPD Generator, and the EPD Hub limits that the tool applies.
8. Multi-product and multi-site EPDs
EPD Hub lets one EPD cover several similar products, or one product made at several production sites (EPD Hub GPI 1.3.1, 2.9 and Annex I). The tool applies the EPD Hub limits. The variation indicator is GWP-fossil, A1–A3, per declared unit. The tool converts each product with its own width and height, or its own mass, so that products of different sizes compare.
One EPD for several products
Rules
A product can join the EPD only if all these conditions are true (P-32):
- It has calculated results.
- It can be converted to the declared unit. For 1 m², its assembly has a width and a height. For 1 kg, it has a mass.
- It has the same PCR and tool version.
- It is not in another EPD draft.
- Its GWP-fossil A1–A3 is not more than 50 % above the lowest product of the group.
One EPD can contain up to 200 other products. The product selector shows the reason when a product cannot join.
Method
The tool selects the method from the spread of GWP-fossil A1–A3 in the group:
| Spread above the lowest product | Method | Declared results |
|---|---|---|
| 10 % or less | Representative product | The results of the product with the lowest GWP-fossil A1–A3 |
| More than 10 %, up to 50 % | Worst case | The highest result of each indicator and module in the group |
The tool fills four EPD details from the method. They are product representation, type of grouping, grouping method and variation. You can change these answers (P-33). A saved answer replaces the calculated answer.
Steps
- Open one product of the group, and then the EPD tab.
- Select Create EPD, and then For all variants of this assembly or For multiple products….
- In the product selector, select the products.
- Examine Included products and the Representative product.
- Under EPD details, examine the method and the variation.
All products in the EPD share the scenarios of the declared product. Differences in A4, A5 and the use stage between products are not declared separately.
One product made at several sites
Your company can make one product at several production sites. The declared result is then the production-weighted average over the sites. The tool calculates the result of each site and its deviation from the declared result.
| Deviation of the sites from the declared result | Site representation |
|---|---|
| Below 10 % | Variation below 10 % |
| 10 % or more, up to 50 % | Variation above 10 % |
| More than 50 % | Not allowed. "Submit for review" is refused. |
Steps:
- Enter the annual volume of the product at each site. See 4. A1–A3 inputs.
- On the EPD tab, examine the Production sites table: the share of production and the deviation of each site.
- Under EPD details, examine the site representation.
The tool models the inbound transport (A2) as one average over the sites. If A2 is 10 % or more of GWP-fossil A1–A3, the tool warns that the site differences can be too small. Below 10 %, the A1–A3 text states that A2 is an average.
Next step
Go to 9. EPD tab.